YGM95 Raymond Mill Mineral Powder Project in Kosonsoy, Uzbekistan

Project overview

This mineral powder workshop in Kosonsoy District, Namangan Region, Uzbekistan operates grinding lines based on YGM-series Raymond mills. Site materials recorded in June 2026 show two mill units together with bucket elevators, classifiers, cyclone collectors, air ducts and blowers. The configuration is intended to produce industrial powder with controlled fineness from carbonate-based and other non-metallic mineral feed.

Process flow

Pre-crushed feed is delivered through a feeder and bucket elevator into the grinding chamber. The material is ground between the rollers and ring, then carried by airflow to the upper classifier. Powder within the target size range is collected by the cyclone system, while oversized particles return to the chamber for further grinding.

• Main Raymond mill with top classifier

• Bucket elevator and feed-transfer section

• Cyclone collector, blower and closed air-duct circuit

• Finished-powder bagging area

Model identification and operating data

The body size, four-roller arrangement and drive layout correspond to the YGM95 (YGM9517) high-pressure Raymond mill configuration. Reference data for this model are: feed size up to 25 mm, adjustable product size of 0.613–0.033 mm (approximately 30–425 mesh), nominal capacity of 2.1–5.6 t/h per line, and a 37 kW main mill motor.

Note: actual output depends on feed hardness, moisture, density and the required product fineness. Two mills are visible in the workshop, so total plant capacity should only be calculated after their parallel operating mode is confirmed.